Home > News

How to Distinguish the Quality of The Pipe Bending Machine?

With the continuous development of domestic industry, quality inspection has become an indispensable part of the Carbon Steel Tube Bending Machine mold manufacturing, and has greatly improved the quality level of the mold industry. In promoting mold standards and mass production, we should do a good job in the convergence of mold standards, promote the coverage of mold standards, and continuously improve the standardization of the industry. At present, the mold industry needs to develop technological innovation to adapt to the current complex situation. The manufacturing level of the mold industry determines the quality of industrial products. Because of the importance of molds, it has always been valued in industrial development. If industries are to develop faster, they need to mobilize various positive factors, and manufacturing technology has become a bending machine. One of the important signs of the development of mold enterprises. At present, the development of the mold industry requires government support, revitalization of the mold industry, the introduction of key equipment and mold market technology, to encourage enterprises in the introduction of high-tech and products.

How to distinguish the quality of the Channel Letter Tube Bending Machine? You can start from several aspects:

Carbon Steel Tube Bending Machine

1. Mould seat hardness and mold hardness are also the key to the normal use of the equipment. When the hardness of the mold base is lower than that of Rockwell HRC60, the hardness of the mold will be lower than that of Rockwell HRC50.

2. Measure the main parameters of the equipment: let the equipment be in the state of dry running, touch each mold block by hand, the hand should not have jitter, otherwise it will be regarded as unqualified product.

3. Put the equipment on the mold, press a sample joint, measure the crimp joint with a caliper or a micrometer, and round and taper should be within 0.1mm, which is excellent.

4. Finally, check the eight-lobed equalization of the equipment mold base and the flatness of the mold. Good equipment will make special control adjustments for these two items, and some poor quality equipment does not control the above two parameters.

Hot Products

Copyright © SLS All Rights Reserved | Sitemap |